Faults |
Causations |
Elimination Methods |
Start Difficulty |
¢ÙAir bubbles in the FO.1ine£® ¢ÚFO£®£¬LO£®£¬trademark not correct ¢ÛStart difficult in the
cool winter£® ¢ÜLeaking air badly of
the Diesel Engine£® ¢ÝDiesel engine
injecting system Can¡¯tworknaturally£® ¢ÞLeakingoilbadly£® ¢ßOperation improperly. |
¢ÙEliminate air and
tight joint ¢ÚAccording to requirement
of instruction ¢ÛPull out sealing tuck and
fill With L.O.2CC. ¢ÜTight studs ofcylinder And/or renew cylinder
washer if necessary£® ¢ÝInspect FO pump£¬FO injector,Eliminate fault or renew parts£® ¢ÞTight or renew washer,etc. ¢ßOperation as
perInstruction£® |
Ram of revolution decrease or stop |
¢ÙThe Governor out of order£® ¢ÚNo supply F.O£® ¢ÛAir in the oil line£® ¢ÜRunning in overtaking loading£® ¢ÝLack of F.O£® ¢ÞToo high heat loading£® |
¢ÙOverbanling andrepair ¢ÚFill oil or check FO
system ¢ÛDrain air ¢ÜAdjust pump operating Condition£® ¢ÝFill F.O. ¢ÞAdjust pump operatingcondition£® |
Smoky exhaust |
¢ÙF.O.injector carbon
accumulation and block up£® ¢ÚHeavy loading ¢ÛTiming lately,part FO
burn in the period of exhaust ¢ÜSuction air tight door
not correct ¢ÝExhaust air not expedite£® ¢ÞExhaust block up |
¢ÙClean or renew
F.O.injector. ¢ÚAdjust pump operating condition£® ¢ÛAdjust the timing£® ¢ÜGrind and clean air tight
door£® ¢ÝDismantle and wash cleaner£® ¢ÞDismantlt and wash exhaust silencer£® |
Bad Vibration and Noise |
¢ÙLooseness in the
connecting location£® ¢ÚGaseous Cavitation Phenomena£® ¢ÛRate of Revolution not
Correct£® ¢ÜDiesel Engine out of order£® |
¢ÙScrew down£® ¢ÚAdjust pump operating
condition ¢ÛControl work rate of revolution£® ¢ÜStop D/E and Ref£®The Instruction book. |
Suction difficulty |
¢ÙSuction line Rubber Washer£® Damaged or its location
not correct£® ¢ÚSuction line fitting
not correct and air bag formed ¢ÛDischarge valve wheel
location not correct ¢ÜVertical pump drain
plug not tight. ¢ÝSuction revolulion low£® ¢ÞWater Sucker oil cup
without oil ¢ßWater Suction
operation not correct |
¢ÙInspect or renew£® ¢ÚProperly fit suction line£® ¢ÛClose the discharge valve
until Complete suction water£® ¢ÜScrew down the drain plug£® ¢ÝIncrease the rate of revolution
for D/E£® ¢ÞFill oil. ¢ßOpecate as per Instruction
Book. |